Clarke CBS225, Инструкция по эксплуатации и техническому обслуживанию

Страница: 19 / 28

19
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
When freehand cutting, always feed the work slowly so that the blade can
follow the line you wish to cut. Make sure not to drag the work off line, forcing
the blade sideways, or twisting it.
In many cases, it is helpful to rough cut about 6mm away from the line. For
difficult curves which may be too tight for the blade, make relief cuts at 90° to
the face of the curve so that these scraps will fall away as the final radius is
sawn.
Each blade has a minimum radius which it will be able to cut, dependant
upon its width. The blade supplied is 10mm wide and able to cut as little as
50mm radius, beyond which the stress may cause it to break. If using a
different blade, a bandsaw blade radius chart should be consulted.