Clarke CBS225, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 28

11
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ASSEMBLY
PREPARATION
For maximum stability the bandsaw should be bolted firmly to either a
workbench, a suitable stand, or a piece of plywood, 5/8” thick, and the
plywood should be clamped firmly to a workbench, using clamps, whenever
the bandsaw is being used.
The saw must be located in an area large enough to allow you to work freely,
taking into account the likely size of your workpiece, and that there should be
adequate lighting.
Make sure also that an adequate electrical supply is close by. Take extra care
if extension leads are used. Make sure that there is no possibility of tripping
over the lead when moving around the work area.
FITTING THE TABLE
1. Rest the bandsaw on its side,
supported by a block of timber
and protect the casing from
damage with cardboard. Fit the
feet to the bandsaw using the
pan head screws and washers.
2. Remove the D-nut and wing
screw from the table (if fitted).
3. Fit the table to the bandsaw using
socket head M8 x 14 bolts and
8mm flat washers. Ensure the saw blade is central in the table slot.
4. Screw the table stop bolt into the underneath of the table.
5. Re-fit the D-nut and wing screw to the table.
6. Fit the push stick hook to the side
of the machine and tighten using
the locking nut.
7. Hang the push stick on the hook.