5
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
2. Do not operate the saw without the guard in position, if the guard does not
function correctly or is not maintained properly.
3.
Never
use your saw without the kerf plate.
4.
Never
place either hand in the blade area when the saw is connected to
the electrical power source.
5.
Never
attempt to stop a saw in motion rapidly by jamming a tool or other
means against the blade; serious accidents can be caused unintentionally
in this way.
6.
Before using any accessory
consult the instruction manual. The improper
use of an accessory can cause damage.
7.
Observe
the maximum speed marked on the saw blade.
8.
Always
wear gloves when handling a saw blade.
9.
Do not
use blades of larger or smaller diameter than recommended. For
the proper blade rating refer to the technical data. Use only the blades
specified in the specifications section of this manual.
10.
Do not
use cracked or damaged saw blades.
11.
Do not
use any abrasive discs.
12.
Raise the blade
from the kerf in the workpiece prior to releasing the switch.
13.
Make sure
that the arm is securely fixed when performing bevel cuts.
14. The blade guard on your saw will automatically raise when the arm is
brought down and will lower over the blade when the arm is raised. The
guard can be raised by hand when installing or removing saw blades or for
inspection of the saw. Never raise the blade guard manually unless the saw
is switched off.
15. Keep the surrounding area of the saw well maintained and free of loose
materials, e.g. swarf and cut-offs.
16.
Before use
, check that the motor air slots are clean and free of swarf.
17. Replace the kerf plate when worn.
18. Disconnect the saw from the mains before carrying out any maintenance
work or when changing the blade.
19.
Never
perform any cleaning or maintenance work when the saw is still
running and the head is not in the rest position.
20. When possible, always mount the saw on to a bench or plywood base
which is then clamped to a bench or mount the machine to a purpose
built mitre saw stand available from your local Clarke dealer.
Содержание C2MS210MP
Страница 24: ......
