16
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PERFORMING A SLIDING CUT
The guide rail allows cutting larger
workpieces using an out-down-back
sliding motion.
1. Release the slide rail lock.
2. Switch the saw on and pull the
saw head towards you (1).
3. Lower the saw blade (2) into the
workpiece and push the head
back (3) to complete the cut.
•
Take extra care if perform sliding
cuts on small workpieces which
are tall enough to be unstable.
•
Remember to lock the saw head
in the rear position when the
sliding cuts are finished.
MITRE CROSS-CUT
1. Release the table mitre lock by
lifting the latch handle and
pressing the locking handle down.
2. Move the arm around until the
pointer lines up with your chosen
position on the mitre scale.
3. Release the latch to lock the table
in your chosen position.
•
The latch will engage with positive
stops at 15
o
, 22.5
o
, 30
o
and 45
o
.
•
Any angle can be set by lifting the locking handle.
4. Proceed as for a vertical straight cross-cut.
NOTE:
When mitering the end of a piece of wood with a small off-cut,
ensure that the off-cut is to the side of the blade with the greater
angle to the fence.
Содержание C2MS210MP
Страница 24: ......
