Clarke C2MS210MP, Инструкция по эксплуатации и техническому обслуживанию

Страница: 18 / 24

18
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
GROOVE CUTTING
Your saw is equipped with a thumbscrew adjuster to provide for groove
cutting.
1. Firstly, determine the depth of
your groove and subtract this
value from the thickness of your
workpiece. This will give you the
height above the table surface at
which the saw blade must be set.
2. Ideally, place a template or a
piece of wood, the same thickness as the saw blade height setting, on the
table beneath the saw blade.
3. Loosen the locking ring and screw
out the depth adjuster.
4. Lower the head so that the blade
lightly touches the template or is
at the correct height as
determined using a ruler.
5. Screw down the adjuster so that it
touches the saw body, then
tighten the locking ring.
• The saw blade is now set to cut
your groove to your set depth.
• The width of the groove will, of course, be the width of the saw blade.
However, by moving the workpiece along the table in small increments (2-
3 mm), each time making a cut, it is possible to cut grooves to any width.
6. Before reverting to normal cutting, remember to slacken the locknut and
turn the adjuster to its normal position, allowing for the full depth of cut.
TRANSPORTING
1. Lower the head and lock it down
using the head lock pin.
2. Slide the head back and tighten
the slide rail lock.
3. Lock the head down with the
locking pin.
4. Lock the bevel clamp handle with
the saw head in the vertical
position.
5. Always lift the saw using the lifting handle.