Clarke 7330347, Инструкция по эксплуатации и техническому обслуживанию, Страница: 24 / 32

24
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
Lack of
pressure (initial
use) Water supply is not
adequate Make sure your water supply can
deliver 25 litres per minute at 20psi
Leak in the high
pressure hose fitting Tighten the fitting, use sealant tape if
required
Nozzle is obstructed Clear the nozzle (See Page 20)
Water filter screen is
clogged Remove and clean the filter (See
Page 18)
Air in the supply hose Turn off the engine
Turn off the water supply,
Disconnect the water supply from
the pump inlet and turn on the water
to expel the air from the hose.
When all the air has been removed,
turn off the water supply and
reconnect the hose.
Turn on the water supply and pull the
trigger to expel any air in the gun/
wand
Power washer
will not draw
detergents Chemical filter is
blocked Clean the filter (See Page 20)
Chemicals being used
are too thick Dilute the chemicals (The chemicals
should have the consistency of
water)
High pressure hose is
too long. Use a longer supply hose instead of a
longer high pressure hose
Chemical build up
inside the chemical
injector Have the parts cleaned or replaced
by your dealer
Water leaking
at the gun /
spray wand
connection Worn or broken O-ring Check and replace
Loose hose
connection Tighten
PROBLEM CAUSE SOLUTION