17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
2. Back away from the surface to be cleaned. The further away you are, the
less the pressure will be on the surface being cleaned.
3. Reduce the speed of the engine (RPM). Slow the engine down and the
water pressure will also go down.
4. Adjust the spray to a wider angle.
• Slide the nozzle forward for low pressure and backwards for high
pressure.
APPLYING DETERGENTS AND CLEANING SOLVENTS
1. Push the detergent hose onto the
ribbed fitting as shown.
2. Place the other end of the
detergent hose with the filter on it,
into a container holding the
chemical/cleaning solution.
3. Slide the nozzle forward for low
pressure operation.
NOTE:
See page 20 for detergent
and cleaning products available from your CLARKE dealer.
SHUTTING DOWN
1. After each use, if you have applied detergents, place the detergent hose
into a container of clean water and run clean water through the detergent
injection system to flush the system thoroughly.
NOTE:
Failure to do so could cause damage to the pump.
2. Set the engine switch to ‘OFF’.
NOTE:
NEVER turn the water off with
the engine running.
3. Turn the water supply off.
4. Pull the trigger on the spray gun to
relieve any water pressure.
5. See storage section in this manual
for proper storage procedures.