19
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10. Release the trigger and switch off the welder and disconnect the machine
from the mains supply.
11. Refit the appropriate size contact tip (the 0.9 mm tip, for no gas welding is
supplied fitted) to suit your wire and replace the shroud.
• A spare 0.6 and 0.9 mm tip are supplied loose and should be used
when using 0.6/0.8 mm mild steel solid wire.
12. Trim the welding wire so that it protrudes no more than 5 mm from the end
of the contact tip.
CONNECTING THE GAS CYLINDER
The welder can be configured to
weld, with or without a gas supply
according to the type of welding
wire being used.
• Mild steel solid core (with gas)
• Flux cored (no gas)
1. Connect a bottled gas cylinder to
the connector at the back of the
welder.
FITTING THE WELDING ROD
Select the appropriate welding rod and insert it into the welding rod holder.
• It should be approximately the same thickness as the workpieces
being welded.
PREPARING THE WORKPIECE
The area being welded should be perfectly clean. Any coating, plating or
corrosion must be removed, otherwise a good weld will be impossible to
achieve.
CONFIGURING THE MACHINE
To prepare the machine for welding it is important that you follow the following
procedure.
Attach the earth clamp to the workpiece as close to the point of welding as
possible without it being intrusive.
Making sure that the ON/OFF switch, located on the rear panel is in the OFF
position, connect the welding leads and gas bottle as follows:
Содержание 6015601
Страница 40: ......
