17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MOUNTING THE WELDING WIRE SPOOL
Select the appropriate wire diameter according to the welding process. After
the wire diameter is selected, check that the wire diameter matches the size
of the wire feeding wheel and the welding torch components.
Spools of welding wire are available from your CLARKE dealer.
1. Open the side panel by pushing
the latches down and allowing
the side panel to open.
2. Remove the locking nut and
retaining spring.
3. Place a spool of welding wire over
the spindle.
• DO NOT release the tension on
the wire, as it will unravel
causing feeding problems later.
• The wire will feed off the spool clockwise from the top of the reel.
• The spool must be fitted in the correct orientation otherwise it will not
feed correctly.
SETTING THE DRIVE ROLLER SIZE
1. Loosen the tensioning knob and
pivot it towards you.
2. Lift up the arm.
3. Take hold of the triangular knob
on the drive roller cover and
rotate it 90°anticlockwise to
release it.
4. Pull the roller retainer off the drive
spindle to reveal the roller.
5. Pull the roller off the drive spindle.
• The groove size is stamped on the corresponding side of the roller.
Select the groove size according to the size of the wire you are using
and put the roller back on the spindle with your chosen side facing
you.
WARNING: MAKE SURE THAT THE WELDER IS NOT CONNECTED TO THE
MAINS SUPPLY.
Содержание 6015601
Страница 40: ......
