10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADDITIONAL PRECAUTIONS FOR MMA WELDING
1.
ALWAYS
ensure that there is full free air circulating around the outer casing
of the machine and that the louvres are unobstructed.
2. A welding arc can seriously damage your eyes. Both operator and
spectators must ALWAYS use a proper welding face shield or helmet with
suitable filter lenses. Proper gloves and working clothes should be worn at
all times.
3.
ALWAYS
remove all flammable materials from the welding area.
4.
NEVER
remove any of the panels unless the machine is disconnected from
the supply and never use the machine with any of the panels removed.
5.
NEVER
use or store in a damp environment. DO NOT EXPOSE TO RAIN.
6.
NEVER
attempt any electrical or mechanical repair unless your are a
qualified technician. If you have a problem with the machine contact your
local CLARKE dealer.
7.
ALWAYS
keep a fire extinguisher handy (Dry Powder, C0
2
or BCF, NOT
Water).
8.
NEVER
continue to weld, if, at any time, you feel even the smallest electric
shock. Stop welding IMMEDIATELY and
DO NOT
attempt to use the machine
until the fault is diagnosed and corrected.
9.
NEVER
allow the earth cable or torch to become wrapped around the
operator or any person in the vicinity.
A comprehensive range of CLARKE safety equipment for use when welding is
available from your local dealer. See page 37.
Consideration should be given to shielding the supply cable of permanently
installed welding equipment, in metallic conduit or equivalent. Shielding
should be electrically continuous throughout its length.
The shielding should be connected to the welding power source so that good
electrical contact is maintained between the conduit and the welding power
source enclosure.
The welding equipment should be routinely maintained according to the
manufacturer’s recommendations (see page 33). All access and service doors
and covers should be closed and properly fastened when the welding
equipment is in operation. The welding equipment should not be modified in
any way except for those changes and adjustments covered in the
manufacturer’s instructions. In particular, the spark gaps of arc striking and
stabilizing devices should be adjusted and maintained according to the
manufacturers recommendations.
Содержание 6015601
Страница 40: ......
