Clarke 3402120, Инструкция по эксплуатации и обслуживанию

Страница: 10 / 24

10
STARTING & OPERATING
Model CLM16 does not incorporate a drive mechanism to its wheels, the machine must
therefore be pushed across the lawn.
MODEL CLM20SP is self-propelled, operated by the Power drive control lever shown in Fig 6
(itemC).
1. Connect the spark plug lead.
2. Ensure the fuel shut-off valve (Fig 5) is in
the ON position. The valve is marked ON/
OFF.
3. If starting from cold, set the choke lever
‘A’, to the ‘START’ position (Fig 7). DO
NOT use the choke if the engine is
already hot.
4. Hold the Control Lever ‘B’ against the
main handle to start the engine. Pull the
starter handle towards you until you feel
the resistance of the engine. Allow the
cord to recoil slowly, then pull the handle
firmly towards you to its full extent to start
the engine. You may need to do this more than once.
When the engine starts, continue holding the control lever towards the main handle to keep
the engine running. Releasing the control lever will cause the engine to stop. THIS IS A
SAFETY FEATURE
WARNING: The blade will be rotating as soon as the engine is
running.
5. After the engine has started, allow it to run
for 30 seconds before mowing. By this
time it should be possible to return the
choke control to the RUN position.
6. Pull the control lever ‘B’, to the main
handle (Fig 7) to increase the engine
speed.
7. To operate the power- drive (model
CLM20SP), follow the above procedure to
start the machine, then, once started,
gently pull the self-propelled drive lever
towards the handle, thereby engaging the
drive. Always start the engine with the drive
disengaged.
8. Releasing the power-drive control lever
stops the drive to the rear wheels. To stop
the mower, - release the power-drive
control lever, then release the throttle lever.
Fig. 6
Fig. 5