MS3001 / MS3200 Installation Manual - Page 17
You can use this chart to quickly identify and interpret the MS3001 / MS3200 system’s chirp
indications and LED flashes.
The system continuously monitors all protected zones, even when it is not armed, and warns
you if it detects a problem when you turn off the ignition.
1. Turn off the ignition.
2. If the siren chirps twice, the system has detected a problem.
3. The status LED will flash to indicate the zone where the problem has been detected.
1 flash
=
door
2 flashes
=
Shock Sensor
3 flashes
=
optional sensor
4 flashes
=
hood / trunk
Full Time System Diagnostics
Reference Chart
1 chirp
arming
normal arming
1 + 3 chirps
arming
Shock Sensor sensitivity is off
1 + 4 chirps
arming
door, hood, or trunk is open
2 quick chirps
arming
Valet Mode is on
LED double flashes
Valet Mode
Starter Defeat Activated
2 chirps
disarming
normal disarming
1 Long + 1 Short Chirp
disarming
Tamper Alert - system was triggered
no LED flashes
after Tamper Alert
ignition
1 LED flash
after Tamper Alert
door
2 LED flashes
after Tamper Alert
Shock Sensor
3 LED flashes
after Tamper Alert
optional sensor
4 LED flashes
after Tamper Alert
hood or trunk
1 chirp
while armed
Warn Away
5 quick chirps
while armed
Dedicated Remote Start Mode
activated
Double chirps
1 minute after disarming
Automatic Rearming
(for 10 seconds)
LED flashing quickly
ignition key off
Passive Arming sequence started
Two chirps
ignition key off
Full Time System Diagnostics
1 LED flash
after Full Time Sys. Diag.
door
2 LED flashes
after Full Time Sys. Diag.
Shock Sensor
3 LED flashes
after Full Time Sys. Diag.
optional sensor
4 LED flashes
after Full Time Sys. Diag.
hood or trunk
Output
When
Status
install_MS3001.qxd 8/11/99 4:15 PM Page 17
