Page 4 - MS3001 / MS3200 Installation Manual
For maximum security, it is best to disguise all under hood system wires with factory style
split loom tubing so that they cannot be easily identified by a thief.
Run all wires from the engine compartment into the interior of the vehicle through a
grommet.
When testing the system, be sure to turn the siren key switch to the “on” position.
EXT2 Extended Range Antenna (optional)
The optional EXT2 is a tuned, coaxial antenna, designed to be used with the MS3001 /
MS3200 security system to increase transmitter range. When properly installed, the EXT2
will add greater installation flexibility to the system, allowing the antenna to be placed high
in the vehicle to achieve maximum range.
Open the cover of the MS3001 / MS3200 main unit and plug the 2-Pin EXT2 connector into
the antenna port located directly on the alarm board, next to the existing antenna. Be sure
that the side of the connector marked with a black dot (center conductor) is facing the side
of the alarm opposite the alarm 14-Pin main connector.
Run the EXT2 cable through the same hole used for the existing antenna. Once you have
replaced the cover, twist the existing antenna around the EXT2 cable to prevent any
potential RF interference.
Route the EXT2 up as high as possible inside the vehicle and be sure to avoid running the
exposed end of the cable along any wire harnesses.
Override Switch
Mount the Override Switch in a location near the driver where it is easily accessible but not
plainly visible. Plug the blue override switch connector into the blue 2-pin socket on the
main unit.
Be sure that the switch cannot accidentally be pressed or damaged by movement of
passengers or contents within the vehicle.
LED Status Indicator
Mount the status LED so that it is visible from both sides of the vehicle. Plug the white LED
connector into white 2-pin socket on the Main Unit.
EXT2 cable
Black Dot
Existing Antenna
Connector
Existing antenna coiled around EXT2
install_MS3001.qxd 8/11/99 4:15 PM Page 4
