English
FZ259
9
9. INSTALLATION
AND WIRE
CONNECTION
1. Before Starting
1. This
set
is
exclusively
for
use
in
vehicles
with
a negative ground 24 V power supply.
2.
Read these instructions carefully.
3. Be sure to disconnect the battery “ ” terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. General Cautions
3. Cautions on Installation
Battery
Figure
1
1.
Do not open the case. There are no user serviceable parts inside. If you drop anything into the unit
during installation, consult your dealer or an authorized Clarion service center.
2. Use a soft, dry cloth to clean the case. Never use a rough cloth, thinner, benzine, or alcohol etc.
For tough dirt, apply a little cold or warm water to a soft cloth and wipe off the dirt gently.
1. Prepare all articles necessary for installing the
source unit before starting.
o
2. Install the unit within 30 of the horizontal
plane. (Figure 2)
3. If you have to do any work on the car body,
such as drilling holes, consult your car dealer
beforehand.
o
Max 30
Figure
2
4. Installation the Source Unit
1. Place
the
mounting
bracket
into
the
instrument
panel
,
use
a
screwdriver
to
bend
each
stopper
of
the
mounting
bracket
inward
,
then
secure
the
stopper
.
2. Wire
as
shown
in
Section
7 .
3. Insert
the
source
unit
into
the
mounting
bracket
until
it
locks
.
4.
Take
care
of
the
top
and
bottom
of
the
trim
ring
and
mount
it
so
that
all
the
hooks
are
locked
.
Note:
1.
Some
car
models
require
special
mounting
kits
for
proper
installation
.
Consult
your
Clarion
dealer
for
details
.
2.
Fasten
the
front
stopper
securely
to
prevent
the
source
unit
from
coming
loose
.
(182
mm
)
7-3/16"
2-1/8
"
53
mm
Hole
Console
opening
dimensions
Before installation, please make sure proper connections are conducted and the unit operates
normally. Improper connection may result in damage to the unit.
Use only accessories designed and manufactured for this unit and other unauthorized
accessories may result in damage to the unit.
Before installation, please fasten all power cables.
DO NOT install the unit in the place where close to hot area to prevent damage to electrical
components such as the laser head.
Install the unit horizontally. Installing the unit more than 30 degree vertically may result in worse
performance.
To prevent electric spark, connect the positive pole first and then the negative pole.
Notes of installation:
Trim ring installation
Attach
the
trim
ring
around
the
front
panel
.
Take
care
of
the
top
and
bottom
of
the
trim ring
and
mount
it
so
that
all
the
hooks are
locked
.
Top
Bottom
Unit installation
1. Insert mounting bracket into dash board,
choose appropriate mounting tab according
to the gap width, bending the mounting tab
outwards with a screwdriver to fix the
mounting bracket in place.
2. Slide the unit into the bracket until you hear a
click sound.
Dashboard
Mounting
Bracket
Screwdriver
Содержание FZ259
Страница 27: ......
