CL-Projects Blue Orb Trilogy, Руководство пользователя, Страница: 10 / 20

9
Time
Sets the glide time between notes when portamento is on. When REL is switched on, the glide time
will increase with the note interval, otherwise the glide time will stay constant regardless of the
interval. The
TIME knob is only accessible when the MODE setting is set to ON or AUTO . The TIME
knob will be reset to 0 when the MODE setting is set to OFF .
UNISONO
The term unisono is used to describe two or more oscillators/voices that are slightly detuned in
correspondence to each other, which makes the sound fatter.
The Saffron synthesizer can use up to 8 unisono voices.
TIP : Point the mouse pointer to the VOICES display and drag up
or down to change the setting.
VOICES
Sets the number of voices played when pressing a key. A maximum of 8 voices can be set.
DET
Detune : Sets the detuning between voices. When used in combination with the VOICES parameter
and with a saw type waveform, this parameter can be used to make those fat supersaw sounds used
in dance music.
SPRD
Spread : Sets the panorama spreading between voices. With a high setting, this makes the patch
sound very wide.
LFO
A Low Frequency Oscillator (LFO) is a very common modulator available on most synthesizers.
Basically, an LFO is an oscillator which works at a set slow rate (perhaps between 0.1Hz to 10 Hz).
Saffron uses 2 different LFO types, a Pitch LFO and a Filter LFO. The Pitch LFO is used to make vibrato
effects. The Filter LFO is very well suited to make those typical wobble sounds and effects that are
used in Dubstep music. The Filter LFO Rate is hardwired to the Modulation wheel so the speed of the
Filter LFO can be modulated by the Modulation Wheel.
At the top right corner of the LFO section, you will find
2 switches ‘ P ’ and ‘ F ’, ‘ P ’ stands for ‘Pitch’ and ‘ F ’ for
‘Filter’ To be able to edit the parameters of the Pitch
LFO, be sure that the ‘
P ’ switch is turned on (lights up).
To be able to edit the parameters of the Filter LFO, be
sure that the ‘
F ’ switch is turned on (lights up).
INT
Intensity : This knob controls how large the parameter changes caused by the modulation signal
changes will be.