CKD GPS3 Series, Инструкция по эксплуатации

Страница: 6 / 40

２．INSTALLATION
２．１ Installation environment
a） Avoid installing this product where it is subject to ultraviolet rays.
b） Prevent installation where the product is exposed to a direct sunlight.
c） Avoid installation at places where there is excessive vibration or impact.
d） Large drainage
Install the air dryer and drain separator before the air filter.
If there is a large drainage from the compressor. Hot and highly humid air could
shorten the device life or result in corrosion.
e） For compressor circuit of water lubrication method
Take measures to prevent chlorine-based substances from entering the
compressed air.
(1) Avoid using this product under the following conditions.
・ Where ambient temperature and product temperature may fall outside the range of 0 to 50℃.
・ The air may be frozen.
・ The humidity is high and the temperature changes largely, causing dew condensation.
・ Sea breeze or seawater is splashed onto the product.
・ Avoid using the product in an atmosphere containing corrosive gas.
・ Avoid using the product in an atmosphere where ozone is produced.
２．２ Installation
a) Securing maintenance space
Please secure enough space for maintenance and inspection.
b） Observe the following items when installing:
・Install this product so the detection port faces downward.
・Install this product at a position higher than the seating surface to prevent coolant
from entering.
・Provide enough space for adjustment, monitoring, and maintenance.
・Do not strike or bump this product.
・When housing this product in a box, provide an exhaust port so atmospheric
pressure is maintained in the box.
・When welding near this product, cover it to prevent spatter from coming in contact.
・When installing this product on a device, check that no load is applied to the device.
CAUTION
CAUTION
INSTALLATION
２
− 5 − [SM-P00143-A]