CKD GPS3 Series, Инструкция по эксплуатации

Страница: 13 / 40

c） Swarf and grinder chips, etc., could clog the nozzle.Switch the supply pressure
(max. 600 kPa) when transporting the workpiece during machining processes to
prevent the detection nozzle from becoming clogged.
d） Select an output format (NPN, PNP) matching the input unit of the programmable
controller being used.
e） Operation may be disabled if a capacitance load such as an AC/DC buzzer is
connected to the load.A protection circuit is provided to prevent damage from
incorrect wiring or overcurrent. A relay must be used when connecting a
capacitance load.
f) Using the master gauge and gap gauge
・Be careful not to be dangerous as it will be adjusted while operating the machine.
Adjustment is 1) gauge set, 2) machine operation, 3) adjustment of this product,
a total of 3 people are required.
・Clearance cannot be set unless the master gauge or gap gauge is accurately
pressed against the detection nozzle.
g) One detection nozzle can be used for one of these product units.
h） Immediately after work is started, the coolant from the nozzle may accumulate in
the pipe and cause the sensor to turn ON for a short time. Wait for coolant to be
discharged by the detection air before starting the machine.
i） If the nozzle becomes blocked, remove the pipe on this product's side and blow out
stuck foreign matter with an air gun. If foreign matter cannot be removed,
poke a needle, etc., through the detection nozzle on the end.
j） If the output setting value is changed, control system devices could operate
unintentionally.
Stop devices before changing settings.
k） Ensure proper operation through periodic inspections.
CAUTION
PROPER
OPERATION
３
[SM-P00143-A] − 12 −