The SHoW DMX Wireless Data System
User’s Manual
Rev 1.4 11-17-08
27 of 48 Pages
After power-up the LCD display will read:
SHoW DMX Rx
SHoW ID: X
alternating with:
SHoW DMX Rx
IN/OUT of Range
and:
Signal: -XXXdBm
The Start Up display reports RF connection status (“In Range” or “Out of Range”),
reports the SHoW ID that the Receiver is configured for (see RF Settings Below), and
reports the RF signal strength.
Press the center ENTER button to access the menus.
SHoW ID:
(1-64) Set the SHoW ID number to match the number calculated by the Transmitter.
RDM Settings
The RDM Settings Menu controls the RDM settings for the Receiver
RDM Proxy Disabled/Enabled:
Enables or Disables the RDM features
Power:
Select the desired RF transmit power setting. For the 5610 (North
American) the available power settings are 5mW, 10mW, 50mW, 100mW, or
125mW FCC. For the 5611, the power settings are 5mW, 10mW, 50mW or
100mW ETSI.
RDM Label:
This is an editable field that allows the user to create a unique
alpha-numeric 32 character RDM label for the unit
Devices Found:
Indicates the number of RDM responder devices discovered by
the Receiver.
RDM Unique ID:
This is a non-editable field that displays the RDM Unique ID
Misc. Settings
Backlight T-Out:
Allows adjustment of the Backlight automatic shutoff time-out
from Always off, through 1-240 seconds on, to Always on
Signal Strength:
Displays the RF signal strength in -dBm
SHoW Status:
Displays In or Out of Range
Firmware version:
Displays the firmware version
Radio Firmware:
Displays the Radio firmware version
Restore Defaults:
Resets all factory defaults, including Backlight Time-out 10
Seconds, Hop pattern 1, Power 10mW, Full Bandwidth broadcast, 512 DMX
Channels (slots), and Show ID 1
