1
2
3
4
47
Operating Manual
QV7.0
4
3
2
1
NOTE:
Always remove the RSP Easy Set in reverse order to installation, i. e. rear edge first,
leading edge afterwards.
•
Inch the press forward until the rear lock-up shaft is easily accessible.
•
Open the clamping screw of the rear lock-up shaft (Fig. 1).
•
Push the locking pin downward using the tommy bar. Release the rear clamp-
ing bar of the base blanket from the fastening clamps of the rear lockup shaft by
shifting the clamping bar downwards in the direction of the centre of the channel
(Fig. 2).
•
Hold the rear clamping bar of the base blanket and packing sheet firmly and feed
out under tension by inching the press backwards until the front lock-up shaft is
accessible Fig. 3).
•
Open the clamping screw of the front lock-up shaft.
•
Push the locking pin downward using the tommy bar. Release the front clamp-
ing bar of the base blanket from the fastening clamp of the front lock-up shaft by
shifting the clamping bar upwards in the direction of the centre of the channel
(Fig. 4).
•
Remove the protective impression cylinder jacket.
WARNING:
To avoid injury, always wear the safety gloves provided when removing the protection
impression cylinder jacket.
7. Removal of the base blanket
(using the example of Heidelberg SM 52)