41
Operating Manual
QV4.0b
6
5
4
•
Insert the clamping bar into the fastening clamps of the rear lock-up shaft by
shifting downwards in the direction of the centre of the channel against the
spring force. The clamping bar and the locking pin have to be fully engaged (Fig. 3
and 4) (check with tommy bar!).
• Tighten the base blanket first at the rear lock-up shaft using a torque wrench set
to 25 Nm. Then tighten the front lock-up shaft (Fig. 5).
•
SM 52 ONLY:
tighten the base blanket over the rubber blanket clamping screw
using a torque wrench set to 25 Nm.
•
Check whether the processing start marking at the leading edge is correctly posi-
tioned, and adjust if necessary (Fig. 6).