1
2
3
4
43
Operating Manual
a CITO GROUP Company
QV4.3
4
3
2
1
BEFORE INSTALLATION OF RSP EASY:
Switch off the plate damper.
Switch off the ink vibrator and the plate inkers.
Remove the printing plate from the plate cylinder.
Install the protective impression cylinder jacket (see page 38).
Remove the rubber blanket and packing sheets.
The automatic rubber blanket or impression cylinder wash-up device must not be used.
Installation of the base blanket into the print unit
•
Inch the press forwards until the rear lock-up shaft is easily accessible (Fig. 1).
•
Insert the rear clamping bar of the base blanket into the rubber blanket lock-up
shaft.
• Turn in the base blanket at the rear edge with lock-up shaft (Fig. 2)
•
Hold the front clamping bar of the base blanket firmly under tension and feed in
by inching backwards, until the front lock-up shaft is accessible.
•
Fit the base blanket at the leading edge and turn in (Fig. 3)
•
Printing unit:
Tighten the base blanket first at the rear lock-up shaft using a
torque wrench set to
25 Nm
. Then tighten the front lock-up shaft (Fig. 4).
•
Coating unit:
Tighten the base blanket first at the rear lock-up shaft using a
torque wrench set to
15 Nm
. Then tighten the front lock-up shaft (Fig. 4).
4.3 Installation of the base blanket
(using the example of KBA Rapida 75)