www.
cistermiser
.co.uk
| 3
2. Installation of internal valve tap
450mm
Water supply
Isolating valve
(not supplied)
8mm AF
Spanner
G3/8 (3/8”
BSP) Female
The tap can be mounted on any horizontal
surface up to 40mm thick. It requires a hole of
32.5-36mm diameter.
Power options
Requires 4 x AA (LR6)
alkaline batteries
Requires 1A fused spur
OR
Multi product power supply unit (not supplied).
Suitable for powering up to 20 units.
OR
NOTE:
Flush pipework prior to installation.
Do not install opposite a mirror.
Minimum 0.5 Bar dynamic pressure.
NOTE:
When installing the inlet pipework, it is good
plumbing practice to ensure that there is an
accessible isolating valve upstream of the tap.
NOTE:
Ensure pre-fitted
filter is retained
within flexible
hose. The tap’s
performance will
be reduce without
the filter.
x 4
x 4
OR
How to change the nozzle
Use the nozzle tool to unscrew the 5 litre (blue)
nozzle. Insert the 3.5 litre (blue) nozzle and
tighten until flush with tap body; no part should
be protruding from the end of the tap. Ensure
the nozzle is not over-tightened as this may
pinch the “O” ring and cause the tap to leak.
