2 Router Card (WS-X3011) Configuration Note
Safety Recommendations
Figure 1
Model WS-X3011 Router Interface Card
The specifications of the router card are listed in Table 1.
Table 1
Router Card Specifications
Safety Recommendations
Follow these guidelines to ensure general safety:
•
Keep the chassis area clear and dust-free during and after installation.
•
Keep tools away from walk areas where you and others could fall over them.
•
Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll
up your sleeves.
•
Wear safety glasses if you are working under any conditions that might be hazardous to your
eyes.
•
Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
Description
Specification
Processor
20-MHz Motorola 68EC030
Memory
8-MB (minimum) dynamic random-access memory
(DRAM) for main memory and shared memory
NVRAM
32-KB nonvolatile random-access memory (NVRAM)
for storing configuration information
Flash
8-MB (minimum) flash memory for running the
Cisco IOS software
Interfaces
1 Ethernet (IEEE
1
802.3) (Internal)
2 Synchronous serial
2
(DB-60)
1 ISDN BRI (RJ-45)
3
1
IEEE = Institute of Electrical and Electronic Engineers.
2
The synchronous serial interface supports the following standards in data terminal equipment (DTE)
and data communications equipment (DCE) mode: EIA/TIA-232, EIA/TIA-449, V.35, and X.21. The
EIA-530 standard is supported in DTE mode only.
3
External network terminal 1 (NT1) device required.
Safety
UL 1950, CSA 22.2-No. 950, Austel TS001,
EN 60950, IEC 950
EMI
FCC Part 15 Class A, VCCI Class II, CISPR 22B,
EN 55022 Class B, CE Marking, Canadian ICES-003
Class A
H8506
SERIAL 1
AUX
SERIAL 0
BRI 0
ETH 0
SERIAL 0
SERIAL 1
BRI 0
DIAG
FLEX SLOT
WS-X3011
