2-6
Cisco VG30D Voice Gateway User Guide
OL-19276-01
Chapter 2 Installation
Power On Self Test and IP Address Setup
Power On Self Test and IP Address Setup
On power ON of the Cisco VG30D Voice Gateway, the unit will perform a self-test. The
Power
LED on
the front panel shows amber, and the four
STATUS
LEDs come on and go off (in sequence from left to
right) to indicate that the unit is performing the self-test. These tests check the correct operation of the
hardware and start the operational software. This process should complete in less than 1 minute.
Successful Self-Test
When all the tests complete successfully
and the software is operational, the
Power
LED ch
anges colour from
amber to green. Approximately 30 seconds later, you can log in to the web-based Gateway Management
Interface.
The Cisco VG30D Voice Gateway has been configured with the default IP address of 192.168.1.1 and
sub-net mask 255.255.255.0.
Proceed
as follows:
Step 1
Connect the ethernet port of the Cisco VG30D Voice Gateway directly to the ethernet port of a computer.
Step 2
Open a web browser and enter
192.168.1.1
directly into the IP address bar.
Note
You may need to change the IP address and sub-net mask of your computer to be on the same
sub-net.
Step 3
Log in to the Cisco VG30D Voice Gateway by using
Advanced
(case sensitive) for both
Username
and
Password
.
Step 4
Browse to
Configuration/Gateway/Set IP Address
.
Step 5
Set Gateway Management IP Address
,
Set Gateway Management Subnet Mask
and, if required,
Set
Management Default Gateway Address
and click the
Submit
button.
Note
The set parameters will get used next time that the Cisco VG30D Voice Gateway gets re-booted,
but the Cisco VG30D Voice Gateway will remain accessible through the active connection until
then.
The Cisco VG30D Voice Gateway may now be powered OFF, installed and connected to the IP network
(accessible through the new IP address). As an alternative, you may continue with further configuration
using the Gateway Management Interface as described in Sections
3
and
4
of the
Cisco VG30D Voice
Gateway User Guide
.
Self-Test Failure
If any test in the sequence fails, the cycle of the
STATUS
LEDs will stop (with one LED remaining on)
and the
Power
LED will remain AMBER.
Содержание VG30D
