2-3
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
OL-1520-05
Chapter 2 Configuring the Cable Modem Termination System for the First Time
Understanding Cisco uBR10012 Router Configuration Fundamentals
Understanding Cisco uBR10012 Router Configuration
Fundamentals
This section describes the basic parameters of using passwords.
Note
These sections provide minimal configuration instructions. For additional configuration information,
refer to subsequent chapters in this guide. For examples of Cisco uBR10000 series CMTS
configuration files, refer to the
“Viewing Sample Configuration Files” section on page 2-17
.
Tip
Be sure that you have appropriate addresses and values based on your network before you attempt to
configure the router. Enter the
show version
command to display the release of Cisco IOS software
on your router.
Using the Enable Secret and the Enable Passwords
The Cisco uBR10012 router is administered using the Cisco command interpreter, called the EXEC. You
must boot and log in to the router before you can enter an EXEC command.
Step 1
Connect a terminal to the I/O controller console port of the Cisco uBR10012 router and establish a
terminal session. You can open a Terminal application (Hyper Terminal) on a PC as follows:
a.
Connect using: Direct to Com 1
b.
Set bits per second: 9600
c.
Set data bits: 8
d.
Set parity: none
e.
Set stop bit: 1
f.
Set flow control: none
Step 2
Power on the Cisco uBR10000 series. Enter
no
to choose the normal operating mode of the router. The
user EXEC prompt appears:
Would you like to enter the initial dialog?[yes]:
no
Router>
Setting Password Protection
Note
For security purposes, the EXEC has two levels of access to commands: user EXEC mode and
privileged EXEC mode. The commands available at the user level are a subset of those available at
the privileged level.
Tip
Because many privileged-level EXEC commands are used to set operating parameters,
password-protect these commands to prevent unauthorized use.
At the EXEC prompt, enter one of the following two commands to set password protection:
•
enable secret
password
(which is a very secure, encrypted password)
•
enable
password
(which is a less secure, nonencrypted password)
To gain access to privileged-level commands, enter the desired password.
