Cisco UCS C220 M3, Инструкция по установке и обслуживанию

Страница: 75 / 134

3-35
Cisco UCS C220 Server Installation and Service Guide
OL-25760-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Replacing a PCIe Card
Caution
Cisco supports all PCIe cards qualified and sold by Cisco. PCIe cards not qualified or sold by Cisco are
the responsibility of the customer. Although Cisco will always stand behind and support the C-Series
rack-mount servers, customers using standard, off-the-shelf, third-party cards must go to the third-party
card vendor for support if any issue with that particular third-party card occurs.
This section includes the following topics:
•
PCIe Slots, page 3-35
•
Replacing a PCIe Card, page 3-36
•
Special Considerations for Cisco UCS Virtual Interface Cards, page 3-37
•
Special Considerations for Cisco UCS Fusion ioDrive2 Storage Accelerator Cards, page 3-37
•
RAID Controller Card Cable Routing, page 3-38
•
Installing Multiple PCIe Cards and Resolving Limited Resources, page 3-38
PCIe Slots
The server contains two toolless PCIe risers for horizontal installation of PCIe cards. See Figure 3-22
and Table 3-7 for a description of the PCIe slots on these risers.
Figure 3-22 Rear Panel, Showing PCIe Slots
PSU1 PSU1 PSU2 PSU2 PSU1 PSU2
331712
PCIe 2
PCIe 1
Table 3-7 PCIe Expansion Slots
Slot Number
Electrical
Lane Width Connector Length Card Length
1
1. This is the supported length because of internal clearance.
1 (on riser 1)
2 (on riser 2)
5
5. Slot 2 is not available in single-CPU configurations.
Gen-3 x8 x16 connector 1/2 length 1/2 height No
Card Height
2
2. This is the size of the rear panel opening.
NCSI
3
Support
3. Network Communications Services Interface protocol
Gen-3 x16 x24 extended 1/2 length Full-height
Yes
4
4. Slot 1 can operate when the server is in standby power mode.