25
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
OL-18677-10
Caveats
CSCug51573
Symptom: When the TCC active DTI port
changes state, SNMP link events are generated for
the other DTI port also.
Conditions: One DTI port is active and the other
DTI port is inactive on TCC card.
Workaround: There is no known workaround.
CSCtu33213
Symptom: Supervisor card crashes during Online
Insertion and Removal (OIR) with the following
error message:
%RFGW-3-UNEXPECTED: ERROR, Unable to send
RPC MSG(type: 1030) sent to src_slot:4,
dest_slot:4 port: depi_plane due to timeout
Conditions: This occurs when line card OIR is
performed.
Workaround: There is no known workaround.
CSCud43963
Symptoms: Downstream channel is in down state
although the DEPI session is established.
Conditions: This issue occurs when changing the
frequency stacking from 4 to 1, the TSID, mode in
sub interface 2~4 is removed from the
configuration. When changing the frequency
stacking back to 4, the TSID configuration
restores to the earlier state. But QAM mode does
not revert back with
no cable downstream
rf-shut
command.
Workaround: Manually configure
no cable
downstream rf-shut
command.
Additional Information: When changing the
frequency stacking on a single port from 4 to 1
and back to 4, the configuration under each QAM
interface restores to the earlier state. However, the
QAM Mode is in “off” state for each QAM
interface. Therefore, the downstream channel is in
down state.
Caveat
Description