IP settings
(When not set by a provisioning system)
The IP parameters are assigned automatically by the network,
or you can set everything manually. If your system is provi-
sioned automatically, manual IP settings may be overridden by
the provisioning system.
If you want to set the parameters manually, contact your
network administrator to obtain the required parameters.
If an IPv4 address is already assigned to the system, you will
find it under
System Information
: Navigate to the gearwheel
icon in the upper left corner on the home screen and
select
System Information.
If you wish to change the IP settings from the default dual
stack setting to either IPv4 or IPv6, this can be done on the
web interface. To set up IPv6 settings manually, use the Touch
controller or the web interface.
NOTE:
When you start up the SX10 or SX20 for the first time,
the Setup assistant starts automatically. The setup wizard skips
the IP settings, if those are already set up by the network.
1. Navigate to the gearwheel icon
on the home screen, and
select
System Information
>
Settings
. Navigate to
Network
Connection
and
select
Network Settings
.
2. Uncheck
Default settings
and
DHCP automatic setup
, if you
want to set the IP address manually.
3. Enter the
IP Address
,
Subnet Mask
and
Gateway
address.
A soft keyboard appears when you select an input field.
Select
OK
to confirm the change.
4. Navigate to the
DNS
section and enter the DNS server
address in the
DNS
Server 1
input field.
5. Select
Apply
to save the changes.
Cisco TelePresence Video Systems
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
21
Getting Started Guide
Introduction
User interfaces
Web interface
On-screen setup assistant
Appendices
Touch
On-screen setup assistant
