Cisco IE 2000, Руководство по установке

Страница: 102 / 102

102
The following configuration command script was created:
hostname Switch
enable secret 5 $1$ZQRe$DPulYXyQLm77v/a4Bmu6Y.
enable password cisco
line vty 0 15
password cisco
no snmp-server
!
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/1
!
interface FastEthernet1/2
!
interface FastEthernet1/3
!
...(output abbreviated)
!
interface GigabitEthernet1/1
!
interface GigabitEthernet1/2
!
end
These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM
by selecting option 2.
Enter your selection [2]:
2
10. Make your selection, and press Return .
After you complete the setup program, the switch can run the default configuration that you created. To change this
configuration or perform other management tasks, use one of these tools:

Command-line interface (CLI)

Cisco Network Assistant (for one or more switches)
To use the CLI, enter commands at the
Switch
> prompt through the console port by using a terminal emulation program
or through the network by using Telnet.
For configuration information, see the switch Cisco IE 2000 Switch Software Configuration Guide or the Cisco IE 2000
Switch Command Reference .
To use the Cisco Network Assistant, see the Getting Started with Cisco Network Assistant guide on Cisco.com.