Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
controller shdsl
68
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
controller shdsl
To configure a controller for high bit rate digital subscriber line (SHDSL) mode, use the
controller shdsl
command in global or controller configuration mode. To disable the controller shdsl command, use the
no
form of this command.
Cisco HWIC-4SHDSL, HWIC-2SHDSL, EHWIC-4SHDSL-EA, and EHWIC-8SHDSL-E
controller shdsl {
slot number/subslot number/port number}
Cisco 888EA
controller shdsl {
port number}
Syntax Description
Command Default
Controller number: 0
Command Modes
Cisco HWIC-4SHDSL, HWIC-2SHDSL, EHWIC-4SHDSL-EA, and Cisco 888EA
Global configuration
Configuration Controller
Cisco IAD2420 Series
Global configuration
Command History
Usage Guidelines
This command is used to configure the controller mode and the controller number.
slot number
Defines the slot on the router in which the high-speed WAN interface cards
(HWIC/EHWIC) is installed.
subslot number
Defines the subslot on the router in which the HWIC/EHWIC is installed.
port number
Defines the port on the router in which the HWIC/EHWIC is installed. By
default, Cisco HWIC-4SHDSL, HWIC-2SHDSL, and EHWIC-4SHDSL-EA
use port number 0.
number
Defines the controller number. The valid controller number is 0.
Release
Modification
11.3(5)AAA
This command was introduced.
12.2(8)T
This command was implemented on Cisco IAD2420 series IADs.
12.4(15)T
This command was introduced for the Cisco HWIC-4SHDSL and
HWIC-2SHDSL running on the Cisco 1841 router, and on the Cisco 2800
and 3800 series access routers.
15.1(1)T
This command was modified to support the Cisco HWIC-4SHDSL-EA.
15.2(2)T
This command was modified to support the Cisco EHWIC-4SHDSL-EA and
Cisco 888EA.
