Purpose
Command or Action
The
no sdm prefer
command and a default
template is not supported.
Note
Returns to privileged EXEC mode.
end
Example:
Step 4
Device(config)#
end
Reloads the operating system.
reload
Step 5
Example:
After the system reboots, you can use the
show sdm prefer
privileged EXEC command to verify the new template
Device#
reload
configuration. If you enter the
show sdm prefer
command
before you enter the reload privileged EXEC command, the
show sdm prefer
command shows the template currently
in use and the template that will become active after a
reload.
Monitoring and Maintaining SDM Templates
Verifying SDM Templates
Use the following commands to monitor and maintain SDM templates.
Purpose
Command
Displays the SDM template in use.
show sdm prefer
The SDM templates contain only those commands that are defined as part of the templates. If a template
enables another related command that is not defined in the template, then this other command will be visible
when the
show running config
command is entered. For example, if the SDM template enables the
switchport
voice vlan
command, then the
spanning-tree portfast edge
command may also be enabled (although it is
not defined on the SDM template).
If the SDM template is removed, then other such related commands are also removed and have to be
reconfigured explicitly.
Note
Verifying Customizable SDM Templates
Use the following commands to verify the customizable SDM Template that will be applied.
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
149
Configuring SDM Templates
Monitoring and Maintaining SDM Templates
