BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK 84XX SERIES
20-BD5605-00
©
2018 BROADSOFT INC.
PAGE 26 OF 34
Step
Command
Purpose
Step 5
Configure the SIP Digest Authentication
Password.
Example:
reg.2.auth.password="bobs"
This is the SIP Digest Authentication
Password. If the Authentication service
is configured on BroadWorks, then the
Digest Auth Password parameters must
be configured to match the BroadWorks
settings.
This line rings when Bob is called,
and so it has Bob’s Authentication
information.
Step 6
(Optional) Enable Barge-In.
Example:
reg.2.bargeInEnabled=”1”
(Optional) Enable the line for barge-in
attempts on active Shared Call
Appearance calls.
4.4.1.3 Hybrid Key System Configuration
Hybrid Key System emulation requires the phone to support assignment of multiple line
keys to a single registering line on the phone. It also requires the phone to limit each line
key to a single call appearance or provide the configurability to roll a new call over to the
next free line key. Any of the locations can be used to originate or receive calls.
The following table describes the configuration required on each of three phones that
would allow the three phones to share one line and provide three call appearances on
each phone.
Step
Command
Purpose
Subscriber Configuration File:
<MACaddress>-ext.cfg
Step 1
Configure the line as shared.
Example:
reg.1.type=”shared”
Configure the line as “shared” (as
opposed to “private”).
Step 2
Configure the number of line keys.
Example:
reg.1.lineKeys=”3”
Specify the number of line keys to
use for a single registration.
Step 3
Configure the number of concurrent calls
per line for a single registration.
Example:
reg.1.callsPerLineKey=”1”
Set the maximum number of
concurrent calls for a single
registration x. This parameter applies
to all line keys using registration x. If
registration x is a shared line, an
active call counts as a call
appearance on all phones sharing
that registration.
Default = 24
4.4.2 Busy Lamp Field Configuration
Spectralink 84xx Series currently does not support this feature.
4.4.3 Feature Key Synchronization Configuration
The Feature Key Synchronization provides synchronization of phone services, such as
Call Forwarding and Do Not Disturb
,
with the settings on BroadWorks for the analogous
services. Configuration of the phone to enable Feature Key Synchronization is described
as follows.
Step
Command
Purpose
Subscriber Configuration File:
<MACaddress>-ext.cfg
