BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK 84XX SERIES
20-BD5605-00
©
2018 BROADSOFT INC.
PAGE 24 OF 34
Step
Command
Purpose
Step 2
Configure the line label.
Example:
reg.2.label=”Joe”
The label is displayed next to the line
key.
Step 3
Configure the Registration User ID.
Example:
reg.2.address="2405551111_2"
This is the register user ID, which is
used to register Bob’s line2 with
BroadWorks.
This should match the SCA line/port
field on Joe’s Shared Call
Appearance page.
Step 4
Configure the SIP Digest Authentication
User ID.
Example:
reg.2.auth.userID="joebrown"
This is the SIP Digest Authentication
User ID. If the Authentication service is
configured on BroadWorks, then the
Digest Auth User ID parameters must be
configured to match the BroadWorks
settings.
This line rings when Joe is called, and
so it has Joe’s Authentication
information.
Step 5
Configure the SIP Digest Authentication
Password.
Example:
reg.2.auth.password="joeb"
This is the SIP Digest Authentication
Password. If the Authentication service
is configured on BroadWorks, then the
Digest Auth Password parameters must
be configured to match the BroadWorks
settings.
This line rings when Joe is called, and
so it has Joe’s Authentication
information.
Step 6
(Optional) Enable Barge-In.
Example:
reg.2.bargeInEnabled=”1”
(Optional) enable the line for barge-in
attempts on active Shared Call
Appearance calls.
4.4.1.2 Joe’s Phone Configuration
The following steps are used to configure line 1 for Joe’s phone. This line rings when Joe
is called, and it has Joe’s authentication information.
Step
Command
Purpose
Subscriber configuration file:
<MACaddress>-ext.cfg
Step 1
Configure the line as shared.
Example:
reg.1.type=”shared”
Configure the line as “shared” (as
opposed to “private”).
Step 2
Configure the line label.
Example:
reg.1.label=”Joe”
The label is displayed next to the line
key.
Step 3
Configure the Registration User ID.
Example:
reg.1.address=”240555222_1”
This is the register user ID, which is
used to register Joe’s line 1 with
BroadWorks.
The register user ID must correspond
with the line/port setting on
BroadWorks.
