Step 5
Tighten the locking thumbscrews on both sides of the interface module. The recommended maximum torque
is 5.5 in.-lb (.62 N-m).
Step 6
Connect all the cables to each interface module.
What to do next
Do not use interface module or power supply ejector handles to lift the chassis; using these handles to lift the
chassis can deform or damage the handles.
Caution
Removing the Interface Module
Before removing the interface module, read the Activating or Deactivating Interface Module section in the
Cisco ASR 920 Series Aggregation Services Router Configuration Guide
Note
Procedure
Step 1
To remove an interface module, disconnect all the cables from each interface module.
Step 2
Loosen the locking thumbscrews on both sides of the interface module.
Step 3
Slide the interface module out of the router slot by pulling on the handles.If you are removing a blank filler
plate, pull the blank filler plate completely out of the router slot using the captive screws.
If the interface module slot is to remain empty, install a blank filler plate (Cisco part number
800-35323-01) over the opening, and secure it with captive installation screws.
Note
Installing the Router
16
Installing the Router
Removing the Interface Module
