Cisco AS5300 - Universal Access Server, Руководство по настройке программного обеспечения, Страница: 62 / 198

Configuring the Modems
Cisco AS5300 Universal Access Server Software Configuration Guide 3-28
Configuring the Modems
Configure the modems to allow users to dial in to your network.
Configure
Table 3-16 Configuring the Modems
Step Command Purpose
1
5300> enable
Password: <password>
5300#
Enter enable mode (also called
privileged EXEC mode).
Enter the password.
You have entered enable mode when the
prompt changes to
5300#
.
2
5300# configure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
5300(config)#
Enter global configuration mode. You
have entered global configuration mode
when the prompt changes to
5300(config)#.
3
5300(config)# modem country mica country name
[or]
5300(config)# modem country microcom_hdms
country name
Specify the country to set the modem
parameters (including country code and
encoding) for MICA modems. The
default is usa if the access server is
configured with T1 interfaces and
e1-default if the access server has E1
interfaces.
Specify the country to set the modem
parameters (including encoding) for
Microcom modems. The default is usa.
Note that the access server will reset the
Microcom modems for the command to
take effect. For a list of country codes,
see Table 3-17 and Table 3-18 later in
this section.
4
5300(config-if)# line 1 48
5300(config-line)#
Enter the number of modem lines to
configure. If you have 48 modems, enter
line 1 48. If 60, enter line 1 60.
Note: There are 12 modems on each
12-port module, and 6 modems on each
MICA 6-port module.
5
5300(config-line)# transport input all
Allow all protocols to be used when
connecting to the line.
6
5300(config-line)# autoselect ppp
Enable remote IP users running a PPP
application to dial in, bypass the EXEC
facility, and connect directly to the
network.
7
5300(config-line)# modem inout
Enable incoming and outgoing calls.
8
5300(config-line)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
Return to enable mode.
This message is normal and does not
indicate an error.