Cisco AS5300 - Universal Access Server, Руководство по настройке программного обеспечения, Страница: 51 / 198

Basic Configuration 3-17
Configure
6
5300(config-ctrl-cas)# country country
use-default
Use defaults for the specified country.
Note: To view the parameters for the
country (if the country defaults are the
same as ITU defaults), enter write term.
The default setting for all countries is
ITU.
See “Country Codes for R2 Signaling”
later in this section for a list of supported
countries.
7
5300(config-ctrl-cas)# answer-signal group-b 6
[or]
5300(config-ctrl-cas)# default answer-signal
group-b 6
[or]
5300(config-ctrl-cas)# no answer-signal group-b 6
controller E1 0
clock source line primary
cas-group 0 timeslots 1-15,17-31 type r2-analog
r2-compelled
cas-custom 0
country singapore use-defaults
category 2 <--- default category for singapore
answer-signal group-b 6 <--- default bxfree
for singapore
5300(config-ctrl-cas)# exit
Sets the cas custom command
answer-signal to group-b to 6.
Cas custom commands include
caller-digits, category, country,
unused-abcd, invert-abcd, metering,
ka, kd, dnis-digits, answer-signal, and
nc-congestion.
Sets answer-signal group-b to the default
ITU value.
Resets answer-signal group-b 6 to the
default value.
Note: The parameters you do not set are
automatically set to the ITU default by
the Cisco AS5300.
After you configure a country with
default settings, the Cisco AS5300
displays a write term, similar to the one
displayed here.
Exits the cas-custom mode.
8
5300(config-if)# exit
5300(config)#
Return to global configuration mode.
9
5300(config)# voice-port
controller-number.channel-number
5300(config-voiceport)#
(Optional) Enter voice port mode for the
port you want to configure. If you have a
voice card, you will need to configure
the voice ports to match the controller
country code.
10
5300(config-voiceport)# compand-type {a-law |
u-law}
(Optional)Configure the port for A-law.
11
5300(config-voiceport)# cptone countryname
(Optional)Configure the regional ring
tone.
12
5300(config-voiceport)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
Return to enable mode.
This message is normal and does not
indicate an error.
Table 3-10 Configuring R2 Signaling (Continued)
Step Command Purpose