Cisco AS5300 - Universal Access Server, Руководство по настройке программного обеспечения, Страница: 18 / 198

Using the Setup Script
Cisco AS5300 Universal Access Server Software Configuration Guide 1-2
To use the setup script take the following steps:
Step 1 Power ON the access server. The power switch is on the rear panel, at the upper right
corner near the power cord, as shown in Figure 1-1.
Figure 1-1 Power Switch Location
Messages will begin to appear in your terminal emulation program window.
Caution Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time
will be interpreted as the first command typed when the messages stop, which might cause you to power cycle
the access server and start over. It will take a few minutes for the messages to stop.
The messages look similar to the following:
Note The displayed messages depend on the Cisco IOS software release and feature set
you selected. The screen displays in this section are for reference only and might not
exactly reflect the messages on your console.
System Bootstrap, Version 12.0(3)T, RELEASED SOFTWARE
Copyright (c) 1994-1998 by cisco Systems, Inc.
AS5300 processor with 32768 Kbytes of main memory
rommon 3 > b flash:2:
program load complete, entry point: 0x80008000, size: 0x5d7b5c
Self decompressing the image :
#################################################################################
###################]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
H10690
Power
switch
Universal access
server