6-5
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-02
Chapter 6 5-GHz Radio Module Upgrade
Installing a 5-GHz Radio Module
Installing a 5-GHz Radio Module
To install a new 5-GHz radio module into your access point, follow the steps below:
Step 1
Before you can install a new 5-GHz radio module, you must remove the access cover or an existing
5-GHz radio module (refer to
“Removing the 5-GHz Radio Access Cover”
or
“Removing a 5-GHz Radio
Module”
).
Step 2
Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 3
Grasp the new 5-GHz radio module by it’s base (with the antenna pointing up) and insert the card into
the access point’s card-bus slot (see
Figure 6-4
).
Figure 6-4
Installing a 5-GHz Radio Module
Step 4
Push the 5-GHz radio module into the slot until you hear a slight click.
1
Access point
3
Access point card-bus slot
2
5-GHz radio module antenna
4
5-GHz radio card
74604
2
1
3
4
