3-17
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
78-16124-01
Chapter 3 Installing IDS-4215
Removing and Replacing the Compact Flash Device
Removing and Replacing the Compact Flash Device
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Caution
Follow proper safety procedures when removing and replacing the compact flash by reading the safety
warnings in
Regulatory Compliance and Safety Information for the Cisco Intrusion Prevention System
4200 Series Appliance Sensor
.
This section describes how to remove and replace the compact flash device in IDS-4215. It contains the
following topics:
•
Removing the Compact Flash Device, page 3-17
•
Replacing the Compact Flash Device, page 3-18
Removing the Compact Flash Device
To remove the compact flash device from IDS-4215, follow these steps:
Step 1
Log in to the CLI.
Step 2
Prepare IDS-4215 to be powered off:
sensor#
reset powerdown
Wait for the power down message before continuing with Step 3.
Note
You can also power down IDS-4215 using IDM.
Step 3
Power off IDS-4215.
Step 4
Remove the power cord and other cables from IDS-4215.
Step 5
Place IDS-4215 in an ESD-controlled environment.
For more information, see
Working in an ESD Environment, page 1-19
.
Step 6
Remove the chassis cover.
For the procedure, see
Removing the Chassis Cover, page 3-11
.
Step 7
Remove the hard-disk drive.
For the procedure, see
Removing the Hard-Disk Drive, page 3-15
.
Содержание AIP-SSM-10
Страница 8: ...Contents viii Installing Cisco Intrusion Prevention System Appliances and Modules 5 0 78 16124 01 ...
Страница 188: ...Glossary GL 20 Installing Cisco Intrusion Prevention System Appliances and Modules 5 0 78 16124 01 ...
Страница 196: ...Index IN 8 Installing Cisco Intrusion Prevention System Appliances and Modules 5 0 78 16124 01 ...