Cisco AIP-SSM-10, Руководство по установке

Страница: 47 / 196

C H A P T E R
3-1
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
78-16124-01
3
Installing IDS-4215
This chapter describes IDS-4215 and how to install it. It also describes the accessories and how to install
them. It contains the following sections:
•
Introducing IDS-4215, page 3-1
• Front and Back Panel Features, page 3-2
•
Specifications, page 3-3
• Accessories, page 3-4
•
Surface Mounting, page 3-5
• Rack Mounting, page 3-5
•
Installing IDS-4215, page 3-7
• Upgrading the BIOS and ROMMON, page 3-9
•
Removing and Replacing the Chassis Cover, page 3-11
• Removing and Replacing the IDE Hard-Disk Drive, page 3-14
•
Removing and Replacing the Compact Flash Device, page 3-17
• Removing and Installing the 4FE Card, page 3-19
Warning Port numbering for onboard interfaces was reversed from IDS 4.x to IPS 5.0 and later. The port naming
convention changed within the IPS application only; the physical chassis label remains unchanged.
To correlate chassis port labels to software port names, refer to
Figure 3-2 on page 3-2
Introducing IDS-4215
IDS-4215 can monitor up to 80 Mbps of aggregate traffic and is suitable for T1/E1 and T3 environments.
With the addition of the four-port fast Ethernet (4FE) card, IDS-4215 supports five sensing interfaces
(10/100BASE-TX), which provide simultaneous protection for multiple subnets.
Note
The 80-Mbps performance for IDS-4215 is based on the following conditions: aggregation of traffic
from all five sensing interfaces, 800 new TCP connections per second, 800 HTTP transactions per
second, average packet size of 445 bytes, and system running Cisco IPS 5.0 software.
The sensing interfaces and the command and control interface are all 10/100BASE-TX.