Installing the Controller
This chapter describes how to install the controller.
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
Statement 1071
Warning
SAVE THESE INSTRUCTIONS
•
Unpacking and Inspecting the Controller, on page 1
•
Preparing for Controller Installation, on page 2
•
Installing the Controller In a Rack, on page 5
•
Initial Controller Setup , on page 9
•
System BIOS and Cisco IMC Firmware, on page 9
Unpacking and Inspecting the Controller
When handling internal controller components, wear an ESD strap and handle modules by the carrier edges
only.
Caution
Keep the shipping container in case the controller requires shipping in the future.
Tip
The chassis is thoroughly inspected before shipment. If any damage occurred during transportation or any
items are missing, contact your customer service representative immediately.
Note
Installing the Controller
1
