Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion, Руководство по установке

Страница: 89 / 464

1-69
Catalyst 6500 Series Switches Installation Guide
OL-5781-08
Chapter 1 Product Overview
Catalyst 6513-E Switch
Table 1-23 lists the features of the Catalyst 6513-E switch chassis.
Table 1-23 Catalyst 6513-E Switch Features
Feature Description
Chassis
•
Thirteen horizontal slots. Slots are numbered from (1) top to (13)
bottom.
Supervisor engines
•
Supports Supervisor Engine 32, Supervisor Engine 720, Supervisor
Engine 720-10GE, and Supervisor Engine 2T.
Note Refer to your software release notes for the minimum software
release versions required to support the supervisor engines.
– Supervisor Engine 32, Supervisor Engine 720, Supervisor
Engine 720-10GE, and Supervisor Engine 2T must be installed in
slot 7 and slot 8.
Note
Slots not occupied by supervisor engines can be used for modules.
Check your software release notes for any restrictions on the type of
module that can be installed.
•
Supervisor Engine 720, Supervisor Engine 720-10GE, and Supervisor
Engine 2T have a built-in switching fabric. Switch Fabric Modules
(WS-C6500-SFM and WS-X6500-SFM2) are not supported.
• Supervisor Engine 32 does not support the Switch Fabric Modules
(WS-C6500-SFM and WS-X6500-SFM2).
•
The uplink ports are fully functional on all redundant supervisor engine
models when they are in standby mode.
Note In systems with redundant supervisor engines, both supervisor
engines must be the same model and have the same daughter card
configurations. Each supervisor engine must have the resources to
run the switch on its own, which means that all supervisor engine
resources are duplicated. Identical supervisor engine memory
configurations are recommended, but are not required as long as the
supervisor engine with the smaller memory configuration is
sufficient to run the configured features of the switch. Additionally,
each supervisor engine must have its own flash device and console
port connections.
Modules
•
Supports up to 12 Catalyst 6500 series modules.
• Slots 1–13 support dual fabric channels.
•
Check your software release notes for specific information on module
support. Some Catalyst 6500 series modules may:
–
Not be supported
–
Require that you install a specific supervisor engine
– Have chassis slot restrictions
–
Require a specific software release level to operate
Backplane bandwidth
•
2 Tbps system bandwidth
• 80 Gbps per slot for all thirteen slots