Cisco 12008, Руководство по установке и настройке, Страница: 352 / 382

Removing and Replacing the Cable Management System
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide 7-72
Step 4
Remove the top trim piece from the chassis by pulling it away from the chassis
fasteners (see Figure 7-24, part 1).
Step 5 Remove the end cap (left-most, large finger piece) from the chassis by pulling it
away from the chassis fasteners (see Figure 7-24, part 2).
Step 6 Pivot the bottom of the cable-management tray away from the recessed router
enclosure (see Figure 7-24, part 3).
Step 7
Remove the cable-management tray from the router and set it aside.
This completes the removal procedure for the Cisco 12008 cable-management tray.
Installing a Cable-Management Tray
This section tells you how to install a cable-management tray in the Cisco 12008.
Note
Before accessing any of the router’s internal components, put on an antistatic wrist
strap and make sure that it makes adequate contact with your skin. Insert the equipment end
of the wrist strap (the banana jack) into the ESD grounding socket on the lower left edge of
the upper card cage (see Figure 7-24).
To install a cable-management tray while the system is operating, perform the following
steps:
Step 1
Remove the replacement cable-management tray from its shipping container.
Step 2
Position the cable-management tray at an angle so that its top is oriented toward
the tray recess in the router enclosure (see Figure 7-25).
Step 3
Pivot the bottom of the cable-management tray inward toward the router until it
is flush against the sheet metal in the tray recess (see Figure 7-25, part 1).
Step 4 Secure the cable-management tray in the recess with the two right-most
installation screws that you set aside in the previous section entitled “Removing
a Cable-Management Tray.”