Cisco 11500 Series, Руководство администратора

Страница: 231 / 392

6-5
Cisco Content Services Switch Administration Guide
OL-5647-02
Chapter 6 Configuring Remote Monitoring (RMON)
Configuring an RMON Event
The following running-configuration example shows the results of entering the
commands in
Table 6-1 .
!************************* RMON EVENT *************************
rmon-event 1
community moonbase_alpha
description “This event occurs when service connections exceed 100"
owner “Boston Tech Lab”
type log-and-trap
active
Table 6-1 RMON Event Configuration Quick Start
Steps and Possible Settings
1. Create an RMON event index from global configuration mode. Enter an
integer from 1 to 65534.
(config)# rmon-event 1
Create Event <1>, [y/n]: y
2.
Assign an existing SNMP community for this event. The specified
community_name is the name of an SNMP community configured using the
snmp trap-host command. This step is required only if the traps are sent to
an SNMP network management station.
(config-rmonevent[1])# community moonbase_alpha
3.
Provide a description for the event. Enter a quoted text string with a maximum
of 127 characters including spaces.
(config-rmonevent[1])# description “This event occurs when service
connections exceed 100”
4.
Assign the owner who defined and is using the resources of the event. Enter a
quoted string with a maximum of 127 characters including spaces. You must
define the owner before you can activate the event.
(config-rmonevent[1])# owner “Boston Tech Lab”
5.
Specify the type of event notification. The type determines where the
notification is sent.
(config-rmonevent[1])# type log-and-trap
6.
Activate the event.
(config-rmonevent[1])# active