Cisco 1130AG - Aironet - Wireless Access Point, Руководство по установке оборудования

Страница: 61 / 138

3-9
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-02
Chapter 3 Configuring the Access Point for the First Time
Assigning Basic Settings
Default Settings on the Express Setup Page
Table 3-1 lists the default settings for the settings on the Express Setup page.
Enabling the Radio Interfaces
In Cisco IOS Release 12.3(4)JA, the access point radios are disabled by default, and there is no default
SSID. You must create an SSID and enable the radios before the access point will allow wireless
associations from other devices. These changes to the default configuration improve the security of
newly installed access points. Refer to the
“Configuring Basic Security Settings” section on page 3-10
for instructions on configuring the SSID.
To enable the radio interfaces, follow these instructions:
Step 1
Use your internet browser to access your access point.
Step 2 When the Summary Status page displays, click Network Interfaces > Radio0-802.11g and the radio
status page displays.
Step 3
Click Settings and the radio settings page displays.
Step 4 Click Enable in the Enable Radio field.
Step 5
Click Apply .
Step 6 Click Radio1-802.11A and the radio status page displays.
Step 7
Repeat Steps 3 to 5.
Step 8 Close your internet browser.
Table 3-1 Default Settings on the Express Setup Page
Setting Default
System Name or Host Name ap
Configuration Server Protocol DHCP
IP Address Assigned by DHCP
1
1.When you connect a 1130AG series access point running Cisco IOS Release 12.3(2)JA or later with a default configuration to
your LAN, the access point requests an IP address from your DHCP server and, if it does not receive an address, continues to send
requests indefinitely.
IP Subnet Mask Assigned by DHCP
Default Gateway Assigned by DHCP
Role in Radio Network Access point (root)
Web Server Standard (HTTP)
SNMP Community defaultCommunity
Optimize Radio Network for Throughput
Aironet Extensions Enable