CIS VCC-5CL4M, Техническое описание и руководство по эксплуатации

Страница: 27 / 36

VCC-5CL4M Rev.905-0060-04
©2016 CIS Corporation. All rights reserved.
26
9. Remote Communication Function
Via camera link serial communication function, the camera can be controlled.
(1)
The settings for serial communication
Baud rate 9,600bps or 115,200bps
Data 8bit
Stop bit 1bit
Parity None
XON/XOFF Not controlled
(2) Control code
・
The total control code conforms to ASCII code.
・
A control code consists of command, parameter and CR (0Dh). The changes and acquisition of setting
parameters can be done by issuing commands from PC.
Command Parameter 1 Parameter 2~7 Function
GU Address Data 1 Obtain setting information
SU Address Data Change of camera settings
INIT None None Restore factory settings
SAVE None None Save the camera settings
GSI 1 None Acquire its model name
As for the address and the data, please refer to “5. Function settings”.
(3) How to set a command
・
Input a command in capital letters
・
Separate between a command and a parameter by one space.
・
From the head of input character to the linefeed code [¥r]or[¥n] is analyzed as one command.
・
With 0x, the parameter shall be analyzed as hexadecimal number, and decimal number without 0x.
・
The identifiable letters from the head are to be analyzed.
・
The returned command from the PC will be received by the camera, and then echoed back.
・
Refer to
“
Section 5. Function settings
”
for the address and data.
・
Do not input values and letters other than the specified above command and those mentioned in
“
Section 5.
Function settings
”
・
Do not issue the next command until the prompt which shows the completion of the prior command is shown.
(4)
Setting Examples
【
Example of Get Command
】
To get the information of the address 21
[Send]
GU[sp]21[¥r] or[¥n]
[Returned value] 50[¥r] [¥n] [Acquired data + Linefeed]
[Returned value] [¥r] [¥n] [Linefeed]
[Returned value] >[sp] [ Space]
【
Example of Set Command
】
To set 30 to the address 21
[Send]
SU[sp]21[sp]30[¥r]or[¥n]
[Returned value] [¥r] [¥n] [Linefeed]
[Returned value] >[sp] [ Space]
[¥r]=CR(0x0D)
[¥n]=LF(0x0A)
[sp]=Space(0x20)