VCC-5CL4M
Rev.905-0060-04
©2016 CIS Corporation. All rights reserved.
9
5.
Camera Function Settings
Camera functions can be set with serial communications.
Function
Address
Data
Description
Camera mode
1
0
2Tap 8bit/10bit
1
3Tap 8bit
2
4Tap 8bit/10bit
3
8Tap 8bit/10bit
Output data selection
2
0
8bit output
1
10bit output (Invalid at 3Tap mode).
Trigger shutter mode
※FAST trigger m ode is forced to be
disabled at normal shutter mode.
To enable FAST trigger mode, fixed
trigger shutter mode or pulse width
trigger shutter model shall be selected
3
0
Normal shutter mode (free-run)
(Shutter speed can be set with address 23 and 24).
1
Fixed trigger shutter mode
(Shutter speed can be set with address 23 and 24).
2
Pulse width trigger shutter mode
(Shutter speed can be set with trigger pulse width).
Trigger polarity
4
0
Positive
1
Negative
Trigger input
5
0
Camera Link CC1
1
12pins circular connector No. 11 pin (TTL)
FAST trigger mode selection
※Trigger m ode to capture the trigger
input with H cycle or the mode to
capture the trigger input with CLK
sync is switchable.
However, please be noted that
overlapped operation cannot be
operative at CLK sync mode.
This mode is effective to avoid hunting
at high speed shutter operation.
6
0
H sync mode (Trigger is taken with H sync.).
※A trigger during outputting im ages can be input (Overlap
operation is doable).
※Exposure tim e during norm al shutter m ode and fixed trigger
shutter mode can be set per H.
1
FAST trigger mode (Trigger is taken with CLK sync.).
※A trigger during outputting im ages cannot be input (Overlap
operation is not doable).
※Exposure tim e of m anual shutter during fixed trigger shutter
mode is changed to be set per μs
(approximate value).
Test pattern
7
0
OFF
1
Gray scale (Valid only when cursor is OFF)
2
Horizontal ramp (Valid only when cursor is OFF)
3
Vertical ramp (Valid only when cursor is OFF)
Cursor display ON/OFF
8
0
OFF
1
ON (Cursor output has its priority when test pattern output is
ON).
Cursor X coordinate
9
0 ~ 2447 Horizontal 2448 pixels (Factory setting is 0.
When operating coordinate, it is reset to (0, 0).)
Cursor Y coordinate
10
0 ~ 2047 Vertical 2048 lines (Factory setting is 0.
When operating coordinate, it is reset to (0, 0).)
Output image horizontal flip
11
0
Normal
When operating the cursor is reset to
(0, 0).)
1
Horizontal flip
Output image vertical flip
When operating the cursor is reset to
(0, 0).)
12
0
Normal
1
Vertical flip
Defective pixel correction
13
0
OFF
1
ON
