2.)
I
nstall the male end of the 6’ Ethernet RJ-45 cable into the
Drive By
port (figure
2.0).
3.)
Power up the
SpreadSmart
TM
or
Datashark
TM
, v
erify that the power led lights on the
wireless bridge (wait about 10-40 seconds)
Figure
1.1
Step 2 – Installation/Removal of SD (Digital Storage) Card
Shut off the power and remove the 4 screws on the access plate that has the
Drive By Data
port (figure 2.0). Grasp the opposite end plate by the silver handle and carefully slide out the PC
board.
HANDLE THE CIRCUIT BOARD WITH CARE!
Figure 2.0
Rev C
Page 7
11/30/2011
Copyright © 2011 by Cirus Controls, LLC. All Rights Reserved. No part of this material may be
reproduced in any form without the express written permission of Cirus Controls LLC.
Bridge Power Input
