Configuring the computer to talk to the Bridge/Access Point:
1.)
S
elect
Start
2.)
Select
Control Panel
3.)
Click on
Network Connections
4.)
Click on the
Local Area Network
icon
5.)
Select
Properties
6.)
Double-click the
Internet Protocol (TCP/IP)
line (figure 4.0)
7.)
Select
Use the following IP address
and enter in an IP address 192.168.0.51 (figure
4.1) for the DWL-2100AP or 169.254.2.101 for the CC501.
8.)
Click
OK
twice to close out the Internet protocol/LAN properties. The computer is
now ready to communicate with a factory default bridge or access point.
Figure 4.0
Figure 4.1
Configuring the Bridge using the Airborne Management Center (AMC)
Install the Quatech CD-only if the AMC utility is not installed on the computer
you’re using. Note: if the DataManagement Suite is > 3.8 this will be located in
C:\Program Files\Cirus Controls\Data Management Suite\Quatech Bridge
Complete “
Configuring the computer to talk to the Bridge/Access Point” section before
proceeding
Programming the Quatech Bridge CC501
Rev C
Page 13
11/30/2011
Copyright © 2011 by Cirus Controls, LLC. All Rights Reserved. No part of this material may be
reproduced in any form without the express written permission of Cirus Controls LLC.
Note: The AirborneDirect Wireless Ethernet Bridge can be configured by
wireless connection, however, only if you have wireless access from
associated computer. To do this setup your computer to be within the same
IP subnet as the bridge, followed by opening the AMC utility.
