* To return this setting to the default position, repeat the above steps,
turning the upper limit adjustment screw counterclockwise. Please be
aware this will not adjust instantaneously, the screen must be retracted,
and re-deployed to reveal change. Be sure not to over adjust as this
can cause damage to the screen.
The tightness adjustment of the tab tension strings
The tab tension strings have been
adjusted for optimal performance before the
screen was shipped from the factory.
However, with factors such as transportation
and long time use, the surface tension may
change slightly. In order to ensure the
screen surface is flat, some adjustments
maybe required. As shown in the diagram,
rotate clockwise to tighten and counter
clockwise to provide slack of the tab tension strings.
Voltage: 100V~120V or 220V~240V
(Refer to label on casing)
Frequency: 50Hz~60Hz
Power: 150W (MAX)
The screen can either be wall mounted or hung from the ceiling.
Choose the most suitable method that will enable the screen to be
located where the entire audience can see the whole screen when it is
fully extended. Ensure the right equipment is used for whichever
method is chosen. When hanging from the wall or ceiling into wooden
studs or joists, use ø6x60mm wood screws. For mounting into brick,
concrete or plaster surfaces, use ø6x60mm screws with the appropriate
Wall Remote
With connecting cable
X1 pc
INSTALLATION METHOD
①
②
③
Parts & Tools Required
User Manual
X1 pc
12 VOLT
Trigger
wire
X1 pcs
Hanging Bracket Screw
6x60mm (Depends on size)
⑤
④
⑥
Mounting Bracket
X 2 pcs
IR Remote
X 1pc
RF Remote
X 1pc
⑦
⑧
PRODUCT ELECTRICAL SPECIFICATIONS
Allen Key Wand
X1 pc
⑨
⑩
Central control cable
X1 pc
RS232
Repeater
X1 pc
